Call now to get tree supporting including tree cutter, tree notch, bush cutting, shrub cutter, stump lop and plenty of other around USA:
Call now +1 (855) 280-15-30
Slip the brake lever into position and align the pivot pin holes.
31 rowsRemove the pivot pin and retain for re-use. Remove and discard the original equipment. Remove the pivot pin and retain for re-use. Remove and discard the original equipment brake lever and pivot lever bushing. 4. Insert the pivot lever bushing (2) from the kit into the new brake lever (1). Jul 28, Joined Oct 23. 2, Posts. Discussion Starter #18 Jul 27, Finally got around to replacing the shaft, bushings and front lever tonight. Took about a half hour and no issues.
The new lever though has a metric bolt so I'm not liking that. Its OK for the 20 it cost but I Estimated Reading Time: 7 mins. a lever, the switch can be very delicate the housing to allow the cover to be opened to permit viewing of the microswitch whilst dissasembly and reassembly take place.
This is a nice tool set for replacing shifter shaft bushings on a Harley.
Damage to the microswitch will prevent it functioning as intended 2. Carefully remove the original lever retaini needed for reassembly. 3. Before removing the OEM Clutch Lever position. Video-How to Replace & Install a Shifter Lever Shaft Seal on a Harley-Davidson.
Video-In this completely free DIY video we show you how to remove and replace a shifter lever shaft seal on a Harley-Davidson motorcycle. It doesn't really matter the year or model of Harley, as this seal and setup has been used for a very long time.
Apr 11, I have a FLHS and the splines on the shift shaft lever are wearing out. The shift rod lever is sloppy on the shaft. I had the shift linkage replaced last year and the mechanic had to remove the primary drive to install the shift rod lever. Can I replace the shaft in the tranny without removing.
Amounts shown in italicized text jbs stump grinding for items listed in currency other than Canadian dollars and are approximate conversions to Canadian dollars based upon Bloomberg's conversion. 30, miles on my Harley and the shifter shaft was in really bad shapebushings were shot.
Saw a youtube video and this tool was used for a simple job that would have been very expensive in a bike shop for parts and labor. This tool was such a worthy investment even if used just stumppruning.bars: